We offer Sugar Discharger (Model No : 07) to the clients located in India and abroad. It is multi-featured design - considered all positive points to its UNIVERSALITY to be best performance.

Salient Features of Sugar Discharger (Model No : 07) offered by us :

• Model No. 07 featured as this unit Suit to any sugar centrifugal machines design charging capacity in Kgs. i.e. 500 / 700 / 1000 / 1250 / 1500 / 1750 / 2000 / 2200 Kgs. of any manufacturer by changing the stroke of cylinders & respectively changes in dimensions of Shaft, Piston & Scrapper Height & casing guide pipe
• This Model No. 07 is Medium Duty; Very Sturdy to its application for above said all capacities of centrifugal machines of any manufacturer
• It has a very special feature of ZERO Backlash when scrapper is at its Plough-In Position; so it remains lesser sugar grains in the basket
• Their shaft is keyless & with increased bore size; so its strength of Pulling up & pushing are increased. Reduces Cycle Timing
• It has provided with the Poly Urethane Seals for pneumatic actuations which having very durable & long life
• Its Swiveling OR In-Out Arrangement has provided at the Top Side of Plough unit
• Its Scrapper can be set / positioned at sequential any position out of 360 Degrees
• Its Plough body can be set at sequential of 22.5 out of 360 degrees
• It scraps the sugar layer very smoothly. In this new special design we have applied considering all positive & negative points here before
• With this design we can use Anti-Clock wise In-Out operation & also Clock wise In-Out operation of Scrapper of Plough
• It has very lesser maintenance work throughout couple of crushing seasons

Plough Instructions for User / Operator

• Pay attention that plough Scrapper should be Swivel In only at 50 RPM
• Keep minimum 3mm. & maximum 6mm. Distance / Gap between Screen & Scrapper
• Fill Lubricants oil / Grease at friction surface as instructed points daily or weekly
• Clean scrapper shaft as well as Up-Down Cylinder shaft wiped by hot water
• Do not damage surface of plough shaft
• Air Pressure should be Minimum 6.5 to 7 Kgs/cm2
• Pay attention & immediate remedy of abnormal working / operation